Exam for engine

NO.28 What is required to use the iSM Automatic System Recovery feature?

NO.29 Refer to the exhibit.

Match each callout to the Dell EMC PowerEdge server model shown.

NO.30 What are the default settings used when applying firmware and a configuration to a replaced part using the Lifecycle Controller?

NO.31 An engineer needs to upgrade a Dell EMC PowerEdge R440 server from a single PSU to dual PSU configuration. There are unused PSU modules from PowerEdge R430 and R420 servers available, and they have the same wattage ratings.
What should the engineer do to complete the task?

NO.32 After completing a disk rebuild operation, a technician needs to configure the system so that the rebuild process happens faster the expense of slowing users down.
Which setting should be changed?

NO.33 What is a valid password option available from the iDRAC9 Unique ID feature?

NO.34 You are Investigating a disk error on a Dell EMC PowerEdge server and discover a Hot Spare has not been assigned to the Virtual Disk Group. Use the simulator to assign the Global Hot Spare. When you have finished using the simulator, dick Next.

NO.35 For security reasons, the Dell EMC PowerEdge server power button must be disabled. Use the System Setup Utility in the simulator to disable the power button. When you have finished using the simulator, click Next.

NO.36 What is the Open Compute Project (OCP) card used for in a Dell EMC PowerEdge server?

NO.37 Starting from which Dell EMC PowerEdge server hardware generation is the Micro SD card in the IDSDM/vFlash module supported?

NO.38 What is a key feature introduced in OpenManage Mobile v2.0?

NO.39 A technician working with a Dell EMC PowerEdge 1 take corrective action?

NO.40 What must be done before upgrading OMSA from the 32-bit to the 64-bit version?

NO.41 What is the drive characteristic of a BOSS M.2 drive in a Dell EMC PowerEdge server?

NO.42 What is a key distinction between 1DRAC8 and 1DRAC9?