QUESTION 92
Which of the following is correct regarding static parameters?

QUESTION 93
Select F5 platforms have which three certifications?

QUESTION 94
Although APM can interoperate with LTM, it is unable to use iRules for advanced processing.

QUESTION 95
An administrator deploys a site in which the load balancer only sees the ingress traffic from the client All egress traffic from the server bypasses the load balancer.
Which type of solution is this?

QUESTION 96
A monitor has been defined with an alias port of 443. All other options are left at their defaults.
The administrator wishes to assign it to a pool of members where the members’ ports vary. Which is the result?

QUESTION 97
What are the two most common methods of placing a BIG-IP device into a network environment?
(Choose two.)

QUESTION 98
Which three of these software modules can you layer on top of LTM on a BIG-IP device? (Choose three.)

QUESTION 99
Which two daemons only run after the entire license process has been completed? (Choose two.)

QUESTION 100
A user’s access to resources can change based on the computer they connect from.

QUESTION 101
What is a common use of an iRule?

QUESTION 102
A device needs to decrypt traffic and send unencrypted traffic to the web server. Which method should the BIG-IP Administrator use?

QUESTION 103
What occurs when a save-config command is issued?

QUESTION 104
A user is building a security policy using the Deployment Wizard and the Rapid Deployment application template. By default, which settings will be applied to the security policy? (Choose 3)

QUESTION 105
Which protocol is used for control and session establishment for streaming media?

QUESTION 106
in which scenario is a full proxy TCP connection required?

QUESTION 107
You have a pool of servers that need to be tested. All of the servers but one should be tested every 10 seconds, but one is slower and should only be tested every 20 seconds. How do you proceed?

QUESTION 108
Click the Exhibit Button an LTM has the 3 virtual servers, a SNAT defined, four self IP addresses defined and the networks shown in the exhibit. Selected options for each object are shown below. Settings not shown are at their defaults.

A connection attempt is made with a source IP and port of 10.20.100.50:80 and a destination IP and port of 10.10.2.10:80. When the request is processed, what will be the source and destination IP addresses?

QUESTION 109
Why would an administrator capture monitor traffic between a BIG-IP and servers?

QUESTION 110
Which three are GTM server dynamic load balancing modes? (Choose three.)