JN0-363 Dumps (2023) Prepare Your Exam With 264 Questions [Q97-Q116] : Exam for engine : http://blog.test4engine.com

NEW QUESTION 97
Click the Exhibit button. In the exhibit, all routers are sending routes to Router B

Which routes will be advertised from Router B to Router D?

BGP routes learned from Router A only

BGP routes learned from Router E only

BGP routes learned from Routers A and C only

BGP routes learned from Routers A, C and E only

NEW QUESTION 98
Which statement correctly describes a characteristic of IPv6 unicast addressing?

Global addresses are in the range of 2002::/16.

Only one loopback address exists, ::1/128.

Link-local addresses are in the range of FF00::/8.

Link-local addresses are in the range of FE00::/12.

NEW QUESTION 99
What is the correct order of BGP attributes for active route selection?

next hop -> local preference -> AS path -> MED -> origin

next hop -> AS path -> local preference -> origin -> MED

next hop -> local preference -> AS path -> origin -> MED

next hop -> origin -> local preference -> AS path -> MED

NEW QUESTION 100
What are tree types of interfaces that can be used in an MX Series device when implementing a virtual switch routing instance? (Choose three.)

Trunk interface

Access interface

Layer 2 logical interface

GRE tunnel interface

Logical tunnel interface

NEW QUESTION 101
Which configuration can be applied to ensure that no more than 600 MAC addresses are learned by a virtual switch?

Option A

Option B

Option C

Option D

NEW QUESTION 102
You are deploying link aggregation groups.

By default, what are two considerations in this scenario? (Choose two.)

There should only be four member links per LAG.

All the ports must have the same speed.

Member links are required to be contiguous ports.

Member links can reside on different members within an MC-LAG.

NEW QUESTION 103
By default, which three criteria are used by the Junos load-balancing algorithm to determine a traffic flow? (Choose three.)

protocol

source port

destination port

source address

destination address

NEW QUESTION 104
Click the Exhibit.

Referring to the configuration shown in the exhibit, which statement is true?

Traffic destined to address 192.168.5.1 will take next-hop 172.16.1.2.

Traffic destined to address 192.168.5.1 will alternate between next-hops 172.16.1.2 and 172.16.1.3

Traffic destined to address 192.168.5.1 will take next-hop 10.0.1.1.

Traffic destined to address 192.168.5.1 will take next-hop 172.16.1.3.

NEW QUESTION 105
You notice that the RID of your router is being taken from the address of your management interface.
What could cause this scenario?

The loopback address was configured with a /32 address.

The loopback address was not configured under [edit protocols ospf].

A suitable loopback address was not configured on the router.

The loopback address was configured under [edit routing-options].

NEW QUESTION 106
An OSPF router does not have a router ID configured.
In this scenario, which statement is correct about the router ID?

The Junos OS will use the IP address assigned to the interface with the lowest MAC address.

A router ID will not be assigned until it is manually configured.

The Junos OS will use the IP address assigned to the loopback interface for the router ID.

The Junos OS will use the IP address assigned to the Interface with the highest priority.

NEW QUESTION 107
Which two statements are true about IBGP on MX Series devices? (Choose two.)

Neighbors can be located anywhere within the AS

Interface Lo0 must be used for peering

It does not support multihop

It is loop free by default

NEW QUESTION 108
Which MPLS feature works with Constrained Shortest Path First (CSPF) to protect against the primary and secondary paths using the same link?

fate-sharing

explicit null configuration

policy control over LSP selection

LSP metrics

NEW QUESTION 109
Which action would you use to connect two virtual switches that are configured on the same router?

Create a VRF routing instance

Create a forwarding routing instance

Connect the virtual switches with a cable

Configure an irb interface

NEW QUESTION 110
How does a Junos device learn about MAC addresses when II is first connected to an Ethernet LAN?

The device sends out a network broadcast message asking tor all devices and MAC addresses on the network and stores this information In addition lo the interface from which the response was received.

The device learns the destination MAC addresses from traffic in the network and stores this MAC address in addition to the interface from which the traffic was received.

The device learns the source MAC addresses from traffic in the network and stores this MAC address in addition to the interface from which the traffic was received.

The device sends out a network multicast message asking for all devices and MAC addresses on the network and stores this Information in addition to the interface from which the response was received.

NEW QUESTION 111
What happens when a packet matches a static route with the next hop parameter set to reject?

The system silently drops the packet

An ICMP message is sent to the source and the packet is forwarded

An ICMP message is sent to the source and the packet is dropped

The packet is forwarded and the packet is marked as rejected in the header

NEW QUESTION 112
Which statement is correct about the FE80;:/10 prefix?

This prefix range is used for the link local address.

This prefix range is used on the loopback interface.

This prefix range is reserved for multicast applications

This prefix range is not reserved.

NEW QUESTION 113
Click the Exhibit button. Given the OSPF network topology shown in the exhibit, you would like to inject external (non- OSPF) routes into the network on Router D

Which two OSPF area types will support this configuration? (Choose two)

stub area

totally stubby area

not-so-stubby area

non-backbone area

NEW QUESTION 114
You must establish an MPLS LSP between two locations. You are required to ensure that the LSP traverses specific routers within the network.
Which solution is correct in this scenario?

Enable traffic engineering within RSVP and enable the Fast Reroute feature

Implement RSVP and define the explicit route the LSP must follow

Implement LDP and define the explicit route the LSP must follow

Enable traffic engineering within LDP and define the explicit route the LSP must follow

NEW QUESTION 115
You have configured multiple IP-IP tunnels across your network to provide connectivity to remote sites.Which technique is used to help the IP endpoints in your network determine the optimal packet size to send across your tunnels?

path MTU discovery

fragmentation discovery

end-to-end MTU discovery

packet throughput discovery

NEW QUESTION 116
You observe that VPN routes are hidden on your PE router Which situation accounts for these hidden routes?

The protocol next-hop is not found in inet.3

The protocol next-hop is not found in mpls 0

The protocol next-hop is not found in bgp I3vpn 0

The protocol next-hop is not found in inet 2

JN0-363 Dumps (2023) Prepare Your Exam With 264 Questions [Q97-Q116]

Juniper JN0-363 Exam Certification Details: