[Nov 27, 2023] GB0-191-ENU Exam Brain Dumps - Study Notes and Theory [Q252-Q275]

admin
November 27, 2023

[Nov 27, 2023] GB0-191-ENU Exam Brain Dumps – Study Notes and Theory [Q252-Q275]

Rate this post

[Nov 27, 2023] GB0-191-ENU Exam Brain Dumps – Study Notes and Theory

Pass H3C GB0-191-ENU Test Practice Test Questions Exam Dumps

Q252. The customer’s network connection looks like:
HostA—-GE0/0–MSR-1–S1/0—–WAN—–S1/0–MSR-2–GE0/0—-HostB
Both routers are factory default configuration.
The four interfaces of the router are configured with correct IP addresses. The two hosts HostA and HostB are configured with IP addresses and gateways. Assuming that all physical connections are normal, then ______. (Multiple choice)

At least one static route needs to be configured on each router to realize the intercommunication between HostA and HostB

At least 2 static routes need to be configured on each router to realize the intercommunication between HostA and HostB

No route is configured on the router, HostA can ping the IP address of interface S1/0 of MSR-2

No route is configured on the router, HostA can ping the IP address of interface S1/0 of MSR-1

Q253. The routing table seen on an MSR router is as follows:
Destination/Mask Proto Pre Cost NextHop Interface
6.6.6.0/24 Static 60 0 100.1.1.1 GE0/0
8.8.8.8/32 Direct 0 0 127.0.0.1 InLoop0
20.1.1.0/24 Static 60 0 100.1.1.1 GE0/0
30.0.0.0/8 RIP 100 1 100.1.1.1 GE0/0
Then the correct analysis of this routing table is ______.

The IP address of GE0/0 on the router is 100.1.1.1

The next hop interface of the route whose destination network segment is 8.8.8.8/32 is InLoop0, indicating that the next hop of the route is a virtual interface similar to Null0, and the route is a black hole route

The router is running RIPv1 because the mask of the destination network segment 30.0.0.0 is a natural mask

The routing table is not the complete routing table of the router, and the complete routing table should have at least the direct network segment route of interface GE0/0

Q254. In the following statement about HDLC, what is wrong is ______. (Multiple choice)

HDLC can run on the same/asynchronous link, so it has a wide range of applications.

The HDLC protocol is a bit-oriented transport layer protocol.

Any bit stream can be transparently transmitted on the HDLC link.

The HDLC protocol uses a unified frame format, so both data messages and protocol messages are transmitted in standard format frames on the HDLC link.

Q255. The correct statement about STP, RSTP and MSTP is ______. (Multiple choice)

RSTP is an optimized version of the STP protocol. The delay for the port to enter the forwarding state is greatly shortened under certain conditions, which shortens the time required for the network to finally reach topological stability.

MSTP cannot converge quickly. When the network topology changes, the originally blocked port needs to wait for a period of time before it becomes the forwarding state.

MSTP is compatible with RSTP, but not compatible with STP.

MSTP can make up for the shortcomings of STP and RSTP. It can not only converge quickly, but also enable the traffic of different VLANs to be forwarded along their respective paths, thereby providing a better load sharing mechanism for redundant links.

Q256. The FTP protocol is a protocol based on ______.

UDP

TCP

SSH

Q257. After configuring the relevant configuration of the Telnet service on the router, the router can be pinged from the PC, but the Telnet router fails, and the PC keeps showing that it is connecting to x.x.x.x. The possible reason is ______. (Multiple choice)

The intermediate network routing configuration is incorrect

The Telnet password is incorrectly set

The router Telnet service is not started

The intermediate network prevents the PC from initiating a connection to the router’s TCP port 23

Q258. On the MSR router, the configuration file is a file saved in ______ format.

Batch file

text file

executable file

database file

Q259. On the MSR router, if you want to download files from FTP Server, you should use the ______ command in the FTP command.

get

put

download

load

Q260. If a port running STP in the Ethernet switch does not receive or forward data, receives and sends BPDUs, and does not perform address learning, then the port should be in the ______ state.

Blocking

Listening

Learning

Forwarding

Waiting

Disable

Q261. Execute the following configuration commands on the router:
[Router] dhcp enable
[Router] server forbidden-ip 192.168.1.10
[Router] server forbidden-ip 192.168.1.254
[Router] dhcp server ip-pool 0
[Router-dhcp-pool-0] network 192.168.1.0 mask 255.255.255.0
[Router-dhcp-pool-0] gateway-list 192.168.1.254
[Router-dhcp-pool-0] dns-list 192.168.1.10
[Router-dhcp-pool-0] expired day 5
After completing the above configuration, which of the following statements are correct? (multiple choice)

The router has a DHCP relay function

There are 252 addresses that the router can assign to the host

The router has a DHCP server function

The host can obtain the DNS server address 192.168.1.10 from the router through the DHCP service

Q262. The Layer 2 Ethernet switch searches the MAC address table for an entry that matches the destination MAC address of the frame, thereby forwarding the frame from the corresponding interface. If the search fails, the switch will ______.

discard the frame

Send the frame from all other ports except the incoming port

Find fast forwarding table

Find routing table

Q263. The messages exchanged between the DHCP relay and the DHCP server use ______.

unicast

broadcast

multicast

anycast

Q264. The basic process of Layer 2 forwarding of an Ethernet switch includes ______.

Add or refresh MAC address table entries according to the source MAC address and VLAN ID information of the received Ethernet frame;

Search the MAC address table according to the destination MAC address, if no match is found, then broadcast in the VLAN corresponding to the message;

If a match is found, but the port corresponding to the entry does not belong to the VLAN corresponding to the packet, then the frame is discarded;

If a match is found and the port corresponding to the entry belongs to the VLAN corresponding to the packet, then the packet is forwarded to that port, but if the port corresponding to the entry is the same as the port that received the Ethernet frame, the packet is discarded. frame

Q265. According to the different ways the switch processes VLAN data frames, the port types of H3C Ethernet switches are divided into ______. (Multiple choice)

access port

trunk port

Mirror port

hybrid port

monitor port

Q266. In the switching network shown in the figure, all switches have enabled the STP protocol.

SWA was selected as the root bridge. According to the information in the figure, the _______ port should be set to the Blocking state. (Multiple choice)

P1 of SWC

P2 of SWC

P1 of SWD

P2 of SWD

Insufficient information, unable to judge

Q267. The two routers MSR-1 and MSR-2 are interconnected through the S0/0 interface, and the two routers learn the routes of the LAN segment by running the RIP protocol.
See the following configuration commands on MSR-1:
[MSR-1-Serial0/0] rip authentication-mode md5 rfc2453 H3C
Then the correct interpretation of this command is ______. (Multiple choice)

Configure RIP to use MD5 plaintext authentication

Configure RIP to use MD5 cipher text authentication

Specify the message format specified by RFC2453 for MD5 authentication

Specify the H3C private extended protocol message format for MD5 authentication

Q268. The customer’s routers MSR-1 and MSR-2 are interconnected through their GigabitEthernet0/0, and RIP is running between the two routers. RIP has correctly completed remote routing learning. The following configuration is added on MSR-1: firewall enable acl number 3000 rule 0 deny udp destination-port eq 520 rule 5 permit ip and this ACL is applied to the inbound direction of MSR-1 interface GigabitEthernet0/0. So ______ .

MSR-1 still has the RIP route to the opposite end

MSR-1 cannot learn the RIP route of the opposite end

MSR-2 still has the RIP route to the opposite end

MSR-2 cannot learn the RIP route of the opposite end

Q269. IPv6 uses ______ notation to represent addresses.

colon hexadecimal

dotted decimal

colon decimal

dotted hexadecimal

Q270. The correct statement about STP, RSTP and MSTP is ______. (Multiple choice)

MSTP is compatible with STP and RSTP.

STP cannot converge quickly. When the network topology changes, the originally blocked port will need to wait for a period of time before it becomes the forwarding state.

Q271. The network administrator of a certain enterprise needs to set a subnet mask to divide the class C network 211.110.10.0 that he is responsible for into at least 8 subnets. How many subnet masks can be used for division? (multiple choice)

Q272. The rate of the D channel in ISDN BRI is ______.

54 Kbps

64 Kbps

36 Kbps

16 Kbps

Q273. On the MSR router, use the ______ command to view the current running version of the device.

display running

display software

display version

display current-version

Q274. Use the ______ command to specify the operating system software to be used for the next startup.

startup

boot-loader

bootfile

boot startup

Q275. The following description of the characteristics of the router is correct ______. (Multiple choice)

It is a network layer device

Route and forward according to link layer information

Provide rich interface types

Can support multiple routing protocols

Loading …

H3C GB0-191-ENU exam is ideal for network engineers, network administrators, and system administrators who work with small- and medium-sized networks. GB0-191-ENU exam covers a range of technical skills, including network design, routing and switching, VLANs, Quality of Service (QoS), and network security. Candidates must demonstrate their knowledge of network protocols, such as TCP/IP and DNS, and their ability to troubleshoot common network issues.

The H3C GB0-191-ENU exam consists of 60 multiple-choice questions that you need to answer in 90 minutes. To pass the exam, you must score at least 60%. GB0-191-ENU exam is available in both English and Chinese languages. You can take the exam at H3C test centers or online through the H3C exam portal. GB0-191-ENU exam fee is $200, and you must register for the exam at least two weeks before your desired test date.

Verified GB0-191-ENU dumps Q&As – GB0-191-ENU dumps with Correct Answers: https://www.test4engine.com/GB0-191-ENU_exam-latest-braindumps.html