Q85. What is used by SR-TE to steer traffic through the network?

Q86. Refer to the exhibit.

How are packets directed through the data plane when SRv6 is implemented?

Q87. Refer to the exhibit.

R3 is:
failing to accept multicast RP information from Domain-A
advertising MSDP SA messages to R1 and R4
receiving SA messages only from R4
Which command must the engineer implement to resolve the issue?

Q88. Refer to the exhibit. Which LSA type is indicated by this router output?

Q89. Which multicast routing protocol is most optimal for supporting many-to-many multicast applications?

Q90. Refer to the exhibit. P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied.
The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other.
Which two actions fix the issue? (Choose two.)

Q91.

Refer to the exhibit. A network operator is getting the route for 10.11.11 0/24 from two upstream providers on
#XR3. The network operator must configure #XR3 to force the 10.11.11.0/24 prefix to route via next hop of
10.0.0.9 as primary when available. Which of these can the operator use the routing policy language for, to enforce this traffic forwarding path?

Q92. Refer to the exhibit.

Refer to the exhibit After recent configuration changes to a customer’s network, a network engineer notices that R2 cannot communicate with R3 Both FastEthemet interfaces on R2 and R3 are up and configured with the correct IP addresses MD5 password configured en R2 and R3 match with no issues What is the minimum change the engineer must make to enable R2 and R3 to communicate and fix the problem?

Q93.

Refer to the exhibit. Which task must you perform on interface g1/0/0 to complete the SSM implementation?

Q94. An engineer is troubleshooting a connectivity issue across the MPLS network and is verifying the forwarding behavior of packets. Which table does the engineer look at to verify the forwarding behavior of an IP packet as it enters the MPLS network at the ingress LSR?

Q95. Refer to the exhibit.

Routers R1 and R2 cannot form a neighbor relationship, but the network is otherwise configured correctly and operating normally. Which two statements describe the problem? (Choose two.)

Q96. Refer to the exhibit. A network engineer has divided AS into confederations. Due to repeated ASN, when the 10.0 0.0/8 prefix from R1 arrives to R2, BGP automatically rejects it.
What should the engineer do to fix the problem so that BGP allows that prefix on R2?

Q97. Which cost is the default when redistributing routes from BGP to OSPF?

Q98. Refer to the exhibit.

P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which action fixes the issue?

Q99. Refer to the exhibit.

Refer to the exhibit. An engineer is troubleshooting an issue with this network and notices that prefixes from R3 are missing on the R1 routing table Due to repeated ASN when the 10 0 0 0’8 prefix from R3 arrives at R1, BGP automatically rejects it There is no prefix-list on R1 which blocks the traffic from R3 What should the engineer do to fix the problem so that BGP allows that prefix on R1?