Exam for engine

QUESTION 14
You have created a case with NetApp Support for an issue with a DS4246 shelf on an ONTAP 9.12.1 system.
They have requested that you provide shelf logs.
What action do you need to take to collect the shelf logs?

QUESTION 15
At what stage is a write acknowledged to a client?

QUESTION 16
Where is a kernel core file stored on a FAS9000 system that is running ONTAP 9.12.1 software?

QUESTION 17
What is the default amount of time that a volume is available for recovery from the volume recovery queue following a volume deletion?

QUESTION 18
What happens when the command diskcopy is run from nodeshell?

QUESTION 19
Which two of the following methods are valid ways to access a node which is not booting? (Choose two.)

QUESTION 20
Which command can you use to confirm successful completion of an ONTAP upgrade?

QUESTION 21
Which two statements are true about an IOM 12 module? (Choose two.)

QUESTION 22
On a NetApp FAS9000 system, which two field replaceable units (FRUs) are supported for replacement without takeover? (Choose two.)

QUESTION 23
What are two valid options for uploading a core file from a node that is running ONTAP 9.12.1 software to NetApp for analysis? (Choose two.)

QUESTION 24
In a SAS stack of shelves, what is the topology of the connection between expander and disk?

QUESTION 25
How do you set environment variables to factory settings?

QUESTION 26
After a panic, the customer asks you to explain the error “watchdog timeout.” Which explanation would be appropriate?

QUESTION 27
A SAS connection is reporting a single PHY down.
What are the two most likely causes? (Choose two.)

QUESTION 28
Which two steps are required to replace a drawer in a DS460c shelf? (Choose two.)

QUESTION 29
Which two commands from the Service Processor can provide information about installed field replaceable units (FRUs)? (Choose two.)

QUESTION 30
You are replacing a boot device on a FAS8300 system that is running ONTAP 9.10P6 software. You attach a USB memory stick to the external USB port on the storage controller but cannot access the memory stick.
What step needs to be performed to access the boot device?

QUESTION 31
Which type of AutoSupport message would you expect to see triggered automatically when ONTAP software detects a NetApp WAFL inconsistency on an aggregate?

QUESTION 32
Which three commands can be used to manually generate a kernel core file? (Choose three.)

QUESTION 33
Which two NetApp tools should be used when troubleshooting the root cause of an unexpected controller reboot? (Choose two.)

QUESTION 34
While performing a health check on a cluster, you notice the following entries in the cluster event log:

Referring to the exhibit, which of the following actions do you take?

QUESTION 35
What are two valid commands that can be used to trigger an AutoSupport? (Choose two.)