QUESTION 234
An engineer must configure interswitch VLAN communication between a Cisco switch and a third-party switch.
Which action should be taken?

QUESTION 235
Refer to the exhibit.

Based on the LACP neighbor status, in which mode is the SW1 port channel configured?

QUESTION 236
Which type of attack is mitigated by dynamic ARP inspection?

QUESTION 237
A device detects two stations transmitting frames at the same time. This condition occurs after the first 64 bytes of the frame is received. Which interface counter increments?

QUESTION 238
Refer to the exhibit.

which path is used by the router for internet traffic ?

QUESTION 239
Refer to the exhibit.

What is the effect of this configuration?

QUESTION 240
Which type of address is the public IP address of a NAT device?

QUESTION 241
Refer to the exhibit.

An extended ACL has been configured and applied to router R2 The configuration failed to work as intended Which two changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20 0 26 from the 10.0.10 0/26 subnet while still allowing all other traffic? (Choose two )

QUESTION 242
A Cisco IP phone receive untagged data traffic from an attached PC. Which action is taken by the phone?

QUESTION 243
Refer to the exhibit.

An engineer is tasked with verifying network configuration parameters on a client workstation to report back to the team lead. Drag and drop the node identifiers from the left onto the network parameters on the right.

QUESTION 244
Which command enables a router to become a DHCP client?

QUESTION 245
Which attribute does a router use to select the best path when two or more different routes to the same destination exist from two different routing protocols?

QUESTION 246
DRAG DROP
Drag and drop the Cisco Wireless LAN Controller security settings from the left onto the correct security mechanism categories on the right.

QUESTION 247
Which file-system management command is used frequently when lOS backups, upgrades, and restores are performed?

QUESTION 248
Which command prevents passwords from being stored in the configuration as plain text on a router or switch?

QUESTION 249
Which statement about DHCP snooping is true?

QUESTION 250
I
What is the purpose of using First Hop Redundancy Protocol on a specific subnet?

QUESTION 251

Refer to the exhibit. After the configuration is applied, the two routers fail to establish an OSPF neighbor relationship. what is the reason for the problem?

QUESTION 252
Refer to the exhibit.

The New York router is configured with static routes pointing to the Atlanta and Washington sites. Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another?
(Choose two.)

QUESTION 253
Refer to the exhibit.

An engineer is tasked with verifying network configuration parameters on a client workstation to report back to the team lead. Drag and drop the node identifiers from the left onto the network parameters on the right.

QUESTION 254
Refer to the exhibit.

The show ip ospf interface command has been executed on R1 How is OSPF configured?

QUESTION 255
Refer to the exhibit.

A packet is being sent across router R1 to host 172.163.3.14. To which destination does the router send the packet?

QUESTION 256
What is the maximum bandwidth of a T1 point-to-point connection?