Exam for engine

NEW QUESTION 97
Click the Exhibit button. In the exhibit, all routers are sending routes to Router B

Which routes will be advertised from Router B to Router D?

NEW QUESTION 98
Which statement correctly describes a characteristic of IPv6 unicast addressing?

NEW QUESTION 99
What is the correct order of BGP attributes for active route selection?

NEW QUESTION 100
What are tree types of interfaces that can be used in an MX Series device when implementing a virtual switch routing instance? (Choose three.)

NEW QUESTION 101
Which configuration can be applied to ensure that no more than 600 MAC addresses are learned by a virtual switch?

NEW QUESTION 102
You are deploying link aggregation groups.

NEW QUESTION 103
By default, which three criteria are used by the Junos load-balancing algorithm to determine a traffic flow? (Choose three.)

NEW QUESTION 104
Click the Exhibit.

Referring to the configuration shown in the exhibit, which statement is true?

NEW QUESTION 105
You notice that the RID of your router is being taken from the address of your management interface.
What could cause this scenario?

NEW QUESTION 106
An OSPF router does not have a router ID configured.
In this scenario, which statement is correct about the router ID?

NEW QUESTION 107
Which two statements are true about IBGP on MX Series devices? (Choose two.)

NEW QUESTION 108
Which MPLS feature works with Constrained Shortest Path First (CSPF) to protect against the primary and secondary paths using the same link?

NEW QUESTION 109
Which action would you use to connect two virtual switches that are configured on the same router?

NEW QUESTION 110
How does a Junos device learn about MAC addresses when II is first connected to an Ethernet LAN?

NEW QUESTION 111
What happens when a packet matches a static route with the next hop parameter set to reject?

NEW QUESTION 112
Which statement is correct about the FE80;:/10 prefix?

NEW QUESTION 113
Click the Exhibit button. Given the OSPF network topology shown in the exhibit, you would like to inject external (non- OSPF) routes into the network on Router D

Which two OSPF area types will support this configuration? (Choose two)

NEW QUESTION 114
You must establish an MPLS LSP between two locations. You are required to ensure that the LSP traverses specific routers within the network.
Which solution is correct in this scenario?

NEW QUESTION 115
You have configured multiple IP-IP tunnels across your network to provide connectivity to remote sites.Which technique is used to help the IP endpoints in your network determine the optimal packet size to send across your tunnels?

NEW QUESTION 116
You observe that VPN routes are hidden on your PE router Which situation accounts for these hidden routes?